Grand Cherokee 2WD V6-3.7L (2008)
NOTE: Grand Cherokee (WK) shown, Commander (XK) similar.
20. Using an assistant, position the windshield (1) over the windshield opening.
21. Using the grease pencil marks or tape as reference points, align the windshield to the windshield opening.
22. Carefully lower the windshield into the windshield opening. Guide the windshield and the rubber seal (2) at the top the windshield into its proper
location.
CAUTION: It is not possible to move the windshield after installation. The windshield should never be pressed into place by more than
one person, because the windshield can break if pressed simultaneously on both sides.
23. Push the windshield inward until the windshield comes into contact with the spacers (4) located on each side and the bottom of the windshield
fence (3).
24. Install the cowl grill See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Top Panel - Removal.
25. Install the rear view mirror onto the windshield See: Body and Frame/Mirrors/Service and Repair/Rear View Mirror - Installation.
26. Install the rain sensor module onto the windshield See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Rain
Sensor/Service and Repair/Installation.
