jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Door Lock/Latch - Inoperative|Page 5775 > < Door Lock/Latch - Inoperative|Page 5773
Page 4
background image

Rear door will not open using either the inside or outside handle. If this condition exists, one or more of the following procedures will be required:

A.

Outside Handle-to-Latch Rod Adjustment. (See Condition 1-A for detailed procedure).

Note:
In order to perform this procedure under this condition, it will first be necessary to:

Remove the interior door trim panel (caution should be used when removing the trim panels due to the short length of the wiring harness and the
potential for switch damage).

Disconnect the outside handle-to-latch rod at the latch to relieve tension.

Disable the child protection lock by pulling forward on the child guard link located inboard of the inside lever on the latch, and opening the door
using the inside remote handle.

B.

Latch and Lock Rod Inspection/Replacement. (See Condition 1-B above for detailed procedure. Refer to Condition 3-C).

C.

Outside Handle Bellcrank Inspection. This should be done during the latch and lock rod inspection procedure. (See Condition 3-C above for
detailed procedure.)

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:
Labor Operation No.

Condition 1 23-41-01-90

1.3 Hrs.

Condition 2 23-41-01-91

0.3 Hrs.

Condition 3 23-41-01-92

0.6 Hrs.

Condition 4 23-41-01-93

0.8 Hrs.

FAILURE CODE: XX - Service Adjustment

Door Lock/Latch - Inoperative|Page 5775 > < Door Lock/Latch - Inoperative|Page 5773