jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Door Lock/Latch - Inoperative|Page 5789 > < Door Lock/Latch - Inoperative|Page 5787
Page 14
background image

DO NOT EXCEED THE MAXIMUM SHIM THICKNESS SPECIFIED IN THE CHART. THE COMBINATION OF 1 GOLD AND 1 SILVER
SHIM IS THE MAXIMUM THICKNESS ALLOWED FOR PROPER THREAD ENGAGEMENT. DO NOT USE TWO GOLD SHIMS OR USE
MORE THAN TWO SHIMS IN COMBINATION.

3.

Loosen the striker screws and add or subtract shims using the chart to obtain the correct latch to striker contact.

4.

Align the striker height centering the striker in the latch opening as shown in Figure 2 and position it inboard or outboard to make the door flush,

5.

Tighten the screws to 30 Nm (250 in.lbs.).

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE: Latch Lock, Rt. Front Door - Replace (Inc. Adjustment)
Labor Operation No:

23-41-02-90

0.5 Hrs.

Latch Lock, Lt. Front Door - Replace (Inc. Adjustment)
23-41-02-91

0.5 Hrs.

Latch Lock, Rt. Rear Door - Replace (Inc. Adjustment)
23-41-02-92

0.5 Hrs.

Latch Lock, Lt. Rear Door - Replace (Inc. Adjustment)
23-41-02-93

0.5 Hrs.

Striker, Door Latch - Adjustment Only
23-41-02-94

0.2 Hrs.

FAILURE CODE:

P8 - New Part

Door Lock/Latch - Inoperative|Page 5789 > < Door Lock/Latch - Inoperative|Page 5787