Grand Cherokee 2WD V8-318 5.2L VIN Y MFI (1994)
3.
Replace any damaged rods.
4.
Test the system for proper function.
TABLE 1
C.
Electrical Connector/Switch Inspections and Possible Replacement.
1.
See 1994 Service Manual, Group 8, Section P, Pages 1-5 titled "Power Door Locks".
Note:
For this condition on the right front door, special attention should be given to the possibility of:
-
Bent pins in the 16-way connector at the left door and the 30-way connector on either front door.
-
Terminal push out in the switches on either front door.
-
Switch housing damage/separation.
CONDITION 2:
Interior door lock slide will not unlock. If this condition exists, one or more of the following procedures will be required:
A.
Inside Remote Handle Bezel Removal and Wiring Harness Inspection.
Note:
This condition will occur mainly on the front doors due to the increased length of the harness at these locations as compared to the rear doors.
1.
Remove bezel attachment screw plug using a small, thin blade instrument and remove screw (Figure 2).
2.
Remove the bezel by pulling out on the handle and sliding bezel out and up.
3.
Inspect routing of wiring harness from switch panel on door trim making sure it does not lay across the face plate of the lock slide.
4.
Reposition harness in proper location.
5.
Replace bezel, screw, and screw plug.
6.
Test the lock slide lever for proper function before closing door.
B.
Outside Handle-to-Latch Rod Adjustment. (See Condition 1-A above for detailed procedure.)
Note:
In order to perform this procedure under this condition, it will first be necessary to remove the interior door trim panel, disconnect the outside
handle-to-latch rod at the latch to relieve tension, and open the door using the inside remote handle.
CONDITION 3:
Rear door will not open using the outside handle. If this condition exists, the following procedure will be required:
