Grand Cherokee 2WD V8-318 5.2L VIN Y MFI (1994)
License Plate Lamp Housing
2. Remove license plate lamp housing nuts from liftgate.
3. Squeeze switch locking tabs inward to release switch from license plate lamp housing.
4. Disconnect switch harness connector.
Switch Removal
5. Separate switch from housing.
INSTALLATION
1. Position switch into license plate lamp housing and connect switch harness connector.
2. Snap switch into place.
3. Install license plate lamp housing.
4. Install liftgate trim panel.
LIFTGATE FLIP-UP GLASS WEATHERSTRIP SEAL REMOVAL
1. Slowly pull seal away from flange around edge of glass opening. Remove it from vehicle.
2. Clean seal flange as necessary
INSTALLATION
1. Position weatherstrip seal with paint dots aligned with window opening corners.
