Grand Cherokee 2WD V8-318 5.2L VIN Y MFI (1994)
Fig. 7 Rear Brake Pad Installed Position
1. Position caliper over rotor and into bracket, ensuring brake pads are positioned as shown.
2. Connect rear brake hose to caliper and install new metal fitting washers, then tighten fitting bolt to specifications.
3. Lubricate caliper mounting bolts, then install and tighten to specifications.
4. Ensure brake fluid reservoir is full, then bleed brakes as outlined under Hydraulic System/Service and Repair/Brake System Bleed.
5. Install wheel and lower vehicle, then turn ignition switch to On position and run HCU pump until it stops.
6. Pump brake pedal several times to seat brake pads. Brake warning indicator lamps should go out.
