Grand Cherokee 2WD V8-318 5.2L VIN Y MFI (1994)
-
XXXX Miles (KM) to Service
-
Coolant sensor bad
-
Oil level sensor bad
-
Washer sensor bad
PERFORM SERVICE
The PERFORM SERVICE message is displayed at ignition ON any time the distance-to-service counter is equal to zero. The distance-to-service
counter is reset by pressing SELECT button, then SET button for 2 seconds. Refer to SETUP for information on changing the service interval.
XXXX MILES-(KM)-TO-SERVICE
The distance-to-service message is displayed at ignition ON or when SELECT is pressed after the time/date has been set. The distance-to-service
counter must not equal zero for the message to display. The distance is expressed in MILES or KILOMETERS (km) depending on the state of the
US/M (in overhead console) input. Vehicles not equipped with an overhead console will have pin 24 of the VIC open for US display, or grounded
for METRIC display.
After the ignition turns ON and while the service reminder is being displayed, momentarily pressing SELECT and then SET for 2 seconds resets
the service reminder. Even though the service reminder is being displayed, SELECT needs to be pressed before SET to reset the service
reminder.
There will be 6 beeps every time the service miles are reset. Refer to Setup.
SENSOR FAULTS
The module displays a message as part of the warning message when it detects an open circuit to the oil, washer or coolant sensor. Refer back to
Level Messages.
