jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Ignition Cable - Engine Miss/Rough Idle or Hard/No Start|Page 870 > < Ignition System - Cross Fire/Ignition Wire Induction|Page 865
Page 1
background image

Ignition Cable: All Technical Service Bulletins
Ignition Cable - Engine Miss/Rough Idle or Hard/No Start

NO: 18-34-95

GROUP: Vehicle Performance

DATE: Dec. 15, 1995

SUBJECT:
Intermittent Engine Miss and/or Rough Idle or Hard Start/No Start

MODELS:
1994 - 1995 (ZJ) Grand Cherokee
1994 - 1995 (XJ) Cherokee
1994 - 1995 (YJ) Wrangler

NOTE:

This bulletin applies to vehicles equipped with 2.5L,4.0L or 5.2L engines built prior to 04-01-94 (MDH 04-01-xx).

SYMPTOM/CONDITION:

Intermittent engine miss and/or rough idle, or hard start/no start may be experienced.

DIAGNOSIS:

This condition may show NO fault codes and may mislead the technician into diagnosing this problem as being related to a base engine component
malfunction, such as stuck lifters or valve train problems.

If the vehicle is brought in for service with vehicle performance complaints (rough idle, engine miss), and the DRB scantool does not show any fault
codes, check ignition cables for the date code of 1st quarter 1994 (1-94) or earlier.

If the vehicle is brought in for service with a hard start or no start condition, secondary voltage output should be checked using an ignition scope. A bad
wire would have a high voltage reading. If a high voltage is found, check ignition cables for the date code of 1st quarter 1994 (1-94) or earlier.

The date code will appear as follows:

NOTE:

Date coding is done quarterly on wires. Example is given below.

------------------------------------------------------------
MOPAR ELECTRONIC SUPPRESSION GX 1-94 AATH
-------------------------------------------------------------

GX = Material Code

1-94 = Date Code - Represents the 1st Quarter of 1994

AATH = Vendor Identification

NOTE:

If the ignition cables are found to be dated the first quarter of 1994 (1/94) or earlier, they should be replaced with cables dated 2nd quarter (2/94) and
later.

REPAIR PROCEDURE:

1.

Replace all wires.

POLICY: Reimbursable within the provisions of the warranty.

Refer to the Labor Operation Time Schedule Manual for the time.

Ignition Cable - Engine Miss/Rough Idle or Hard/No Start|Page 870 > < Ignition System - Cross Fire/Ignition Wire Induction|Page 865