Grand Cherokee 1994 V8-318 52L VIN Y MFI Front Clutch Service and Repair
15. Using a suitable gauge bar and dial indicator, measure clutch pack clearance.
a. Position gauge bar across the clutch drum with the dial indicator pointer on the pressure plate.
b. Using two small screw drivers, lift the pressure plate and release it.
c. Zero the dial indicator.
d. Lift the pressure plate until it contacts the snap-ring and record the dial indicator reading. Clearance should be 0.64 - 1.14 mm (0.025 - 0.045
inch). If clearance is incorrect, steel Plates, discs, selective snap ring and pressure plates may have to be changed. The selective snap ring
thicknesses are:
-
0.107 - 0.109 inch
-
0.098 - 0.100 inch
-
0.095 - 0.097 inch
-
0.083 - 0.085 inch
-
0.076 - 0.078 inch
-
0.071 - 0.073 inch
-
0.060 - 0.062 inch
16. Coat rear clutch thrust washer with petroleum jelly and install washer over input shaft and into clutch retainer. Use enough petroleum jelly to hold
washer in place.
17. Set rear clutch aside for installation during
