jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Driver/Vehicle Information Display|Description|Page 9236 > < Driver/Vehicle Information Display|Description|Page 9234
Page 3
background image

COMPASS/TEMPERATURE/TRIP COMPUTER MODE

This display provides the outside temperature, one of the eight compass headings to indicate the direction the vehicle is facing, and vehicle trip
information. The compass and temperature display is the normal display. When the C/T button is pressed the compass/temperature display returns.

The trip computer function will be displayed if the STEP button is pressed from the Compass/Temperature display mode. The trip computer displays the
following information:

-

Average Fuel Economy/Fuel Saver Mode (5.7L Engine Only)

-

Distance To Empty

-

Trip A

-

Trip B

-

Elapsed Time

-

Service Distance

-

Display Units of Measure in

-

Tire pressure display (if equipped)

-

Oil Pressure (SRT-8 only)

-

Oil Temperature (SRT-8 only)

OIL CHANGE REQUIRED (GASOLINE ENGINES ONLY)

This vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will flash in the EVIC display for
approximately 10 seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is
duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style.

Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily,
press and release the MENU button. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following
procedure.

-

Turn the ignition switch to the ON position (Do not start the engine).

-

Fully depress the accelerator pedal, slowly, three times within 10 seconds.

-

Turn the ignition switch to the OFF/LOCK position.

NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this
procedure.

HANDS FREE TELEPHONE MODE - IF EQUIPPED

Provides the following information and features for the optional hands-free communications system:

-

Phone status: idle, voice mail, roaming, battery strength and signal strength in increments of 20 percent

-

Call status: Incoming call, connecting, connected, air time in minutes and seconds, call ended, busy, call failed, roaming and no phone connection

-

UConnect Active

-

Caller ID phone number display

UNIVERSAL GARAGE DOOR TRANSCEIVER

The Electronic Vehicle Information Center (EVIC) features a driver-interactive display which includes HomeLink system messages. For additional
information on the universal transceiver See: Garage Door Opener Transmitter/Description and Operation.

Driver/Vehicle Information Display|Description|Page 9236 > < Driver/Vehicle Information Display|Description|Page 9234