Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Driver/Vehicle Information Display: Removal and Replacement
Electronic Vehicle Information Center - Removal
REMOVAL - ELECTRONIC VEHICLE INFORMATION CENTER CONTROL SWITCH
1. Disconnect and isolate the battery negative cable.
2. Remove the driver airbag, See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Airbag - Removal.
3. Using a trim stick (special tool # C-4755) or equivalent, gently pry the switch and bezel assembly (3) away from the steering wheel at the inner
retaining tab (1) and the outer bezel edge (2).
4. With the switch and bezel assembly free from the steering wheel lift the assembly up and disconnect the switch electrical connector.
5. Using a trim stick (special tool # C-4755) or equivalent, gently pry the switch bezel retainers (2) away from the switch tabs (1) while applying
pressure to the back side of the switch. Remove the switch from the bezel.
Electronic Vehicle Information Center - Installation
INSTALLATION - ELECTRONIC VEHICLE INFORMATION CENTER CONTROL SWITCH
1. Position the steering wheel switch onto the switch bezel aligning the switch tabs (1) with the bezel retainers (2).
2. Press the switch into the bezel until the switch is held in place by all four retainers.
