Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Trunk / Liftgate Handle: Service and Repair
Installation
INSTALLATION
1. Position the latch handle (2) onto the outside of the liftgate and seat the wiring grommet.
2. Seat the latch cable clips.
3. Working through the clearance hole in the inside of the liftgate panel, install the liftgate release cable bracket and install the two nuts (1).
4. Tighten the nuts to 6 Nm (55 in. lbs.).
5. Connect the latch cable to the handle.
6. Connect the electrical connector of the latch handle on the inside of the liftgate.
