Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
4. Position the seat belt turning loop (4) onto the height adjuster (5) on the upper b-pillar. Be certain that the seat belt webbing between the retractor
and the turning loop is not twisted.
5. Install the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. Lbs.).
6. Insert the upper tabs of the turning loop trim cover into the slots of the height adjuster on the upper b-pillar, then lower the bottom of the cover and
use hand pressure to press firmly and evenly on the cover until it snaps into place.
C-Pillar Trim Panel-Removal
REMOVAL
1. Remove the bolts that secure the rear passenger seat cushion to the floor, See: Seats/Seat Cushion/Service and Repair/Seat Cushion - Removal.
