jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Procedures|Page 6532 > < Procedures|Page 6530
Page 2
background image

7. Remove the four axle flange nuts (1).

8. Remove the axle shaft (1) from the rear differential See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Axle

Shaft/Service and Repair/Rear Axle - C213R/Removal.

9. Remove the shoe to shoe return spring (6) with needle nose pliers & then remove the adjuster (5).

10. Remove the shoe to shoe return spring (3) with brake pliers.
11. Remove shoe hold-down clips (4) and pins. Clip is held in place by pin which fits in clip notch. To remove clip, first push clip ends together and

slide clip until head of pin clears narrow part of notch. Then remove clip (4) and pin.

12. Remove shoes (1) off the actuator lever (2) for the park brake then remove the shoes (1).

Brake Shoes - Installation

INSTALLATION

Procedures|Page 6532 > < Procedures|Page 6530