Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
8. Position the blend door actuator (1) into the vehicle.
9. Install the blend door actuator onto the right side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the blend door cam (4).
10. Install the screws (1) that secure the blend door actuator (2) to the right side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
11. Connect the HVAC wire harness connector (4) to the blend door actuator.
12. On LHD models, install the glove box into the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair/Instrument Panel Glove Box - Installation.
13. On RHD models, install the instrument panel silencer onto the driver side of the instrument panel.
14. Reconnect the negative battery cable.
