Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
8. Position the blend door actuator (1) into the vehicle.
9. Install the blend door actuator onto the right side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the blend door cam (4).
10. Install the screws (1) that secure the blend door actuator (2) to the right side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
11. Connect the HVAC wire harness connector (4) to the blend door actuator.
12. On LHD models, install the glove box into the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair/Instrument Panel Glove Box - Installation.
13. On RHD models, install the instrument panel silencer onto the driver side of the instrument panel.
14. Reconnect the negative battery cable.
Mode Door Actuator - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: The heater-A/C system is equipped with two mode door actuators. One for the air doors for the outlets in the instrument panel and one
for the air door for the rear seat/console outlets.
PANEL/DEFROST/DEMIST/FLOOR
