Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Control Assembly: Service and Repair
A/C Heater Control - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: ATC A/C-heater controls are NOT interchangeable between other model years or other vehicle lines. If replacement of the A/C-heater
control is required, only use the control designed for the vehicle being serviced.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel (1) from the instrument panel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel Center Bezel - Removal.
3. Remove the screws (2) that secure the electronic vehicle information center (EVIC) control (3) and the A/C-heater control (4) to the center bezel
and remove the controls.
