Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Headlamp Bulb: Service and Repair
Removal
Boot - Headlamp Bulb
BOOT - HEADLAMP BULB
WARNING: To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the
proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of
death caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials
in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused
by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements.
There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming
into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart
pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable
materials and ensure sufficient ventilation in the working area.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Remove the front lamp unit from the front of the vehicle. See: Service and Repair/Front Lamp Unit - Removal.
2. Remove the low or high beam headlamp bulb from the front lamp unit housing. See: Service and Repair/Front Lamp Unit - Removal.
3. Pull the outer circumference of the low beam boot (3) or high beam boot (1) up and away as necessary to disengage it from the boot collar
formation on the back of the lamp housing.
4. Pull the inner circumference of the low beam boot or high beam boot up and away as necessary to disengage it from the bulb collar formation on
the back of the lamp reflector.
5. Remove the boot from the back of the front lamp.
Bulb - Halogen Headlamp
BULB - HALOGEN HEADLAMP
WARNING: To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the
proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of
death caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials
in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused
by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements.
There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming
into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart
pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable
materials and ensure sufficient ventilation in the working area.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
