Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Turn Signal Bulb: Service and Repair
Front Lamp Unit
Removal
BULB - PARK/TURN SIGNAL
WARNING: To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the
proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of
death caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials
in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused
by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements.
There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming
into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart
pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable
materials and ensure sufficient ventilation in the working area.
1. Disconnect and isolate the battery negative cable.
2. If equipped, remove the cover from over the top of the front lamp unit. See: Headlamp/Service and Repair/Front Lamp Unit - Removal.
3. Firmly grasp the park/turn signal bulb socket (4) on the back of the front lamp unit housing (5) and rotate it counterclockwise about 30 degrees to
unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
Installation
BULB - PARK/TURN SIGNAL
WARNING: To avoid serious or fatal injury when working on the High Intensity Discharge (HID) headlamp system, be certain to take the
proper precautions. The headlamp switch must be in the OFF position. Disconnect and isolate the battery negative cable. There is a risk of
death caused by contact with high voltage used in the HID headlamps. There is a risk of explosion or fire caused by highly flammable materials
in the vicinity of damaged HID lighting elements. There is a risk of injury caused by exposure to Ultra Violet (UV) light, a risk of burns caused
by high component operating temperatures, a risk of mercury poisoning through glass splinters produced by bursting HID lighting elements.
There is also a risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming
into contact with the skin. Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart
pacemakers) must never work on HID headlamps. Wear insulated safety shoes, safety glasses and protective gloves. Remove flammable
materials and ensure sufficient ventilation in the working area.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
