Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Air Bag: Service and Repair
Side Curtain Airbag - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
WARNING: To avoid serious or fatal injury when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should
be worn. There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation to the skin and
eyes.
WARNING: To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the side curtain airbag, or
becoming entrapped between the side curtain airbag cushion and the headliner. Failure to observe this warning could result in occupant
injuries upon airbag deployment.
NOTE: The following procedure is for replacement of an ineffective or damaged side curtain airbag. If the airbag is ineffective or damaged, but
not deployed, review the recommended procedures for handling non-deployed supplemental restraints. See: Service and Repair. If the side
curtain airbag has been deployed, review the recommended procedures for service after a supplemental restraint deployment before removing
the airbag from the vehicle. See: Repairs and Inspections Required After a Collision/Service and Repair.
1. Check to be certain that the two U-nuts for the side curtain airbag inflator bracket and the six box nuts for the airbag channel are properly installed
in the inner roof rail and that they are in good condition.
2. Position the side curtain airbag into the vehicle as a unit.
3. Engage the integral hooks on the side curtain airbag inflator mounting bracket into the locating holes in the inner roof side rail near the D-pillar.
4. Install and tighten the two screws that secure the inflator mounting bracket to the U-nuts in the inner roof side rail. Tighten the screws to 6 Nm (50
in. lbs.).
NOTE: Be certain that the airbag cushion is not twisted during installation. If a colored stripe (red for right side bag, blue for left side
bag) is visible on the cushion, the bag is twisted and must be untwisted before it is secured to the roof side rail.
5. Engage the two plastic push-in fasteners that secure the airbag cushion channel to the roof side rail at the top of the C-pillar.
6. Engage the two plastic push-in fasteners that secure the channel to the roof side rail at the top of the B-pillar.
7. Install and tighten the six screws that secure the airbag channel to the box nuts in the inner roof side rail. Tighten the screws to 6 Nm (50 in. lbs.).
8. Engage the hook on the end of the side curtain airbag front tether into the slot in the inner A-pillar.
9. Engage the two plastic retainers that secure the side curtain airbag front tether to the inner A-pillar.
