Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the instrument panel from the passenger compartment of the vehicle. See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel - Removal.
3. Place the instrument panel on a suitable work surface with the top pad facing down. If the top pad will be reused, be certain to take the proper
precautions to prevent the top cover from receiving cosmetic damage during the following procedures.
4. Disconnect the passenger airbag pigtail wire connector from the instrument panel wire harness connector for the airbag. This connector is secured
to the passenger airbag mounting bracket. To disconnect the connector:
a. Slide the red Connector Position Assurance (CPA) lock on the top of the connector toward the side of the connector.
b. Depress the connector latch tab and pull the two halves of the connector straight away from each other.
5. Remove the two screws (1) that secure the airbag mounting bracket to the instrument panel structural support (2).
6. Remove the top pad from the instrument panel.
7. Disengage each of the hooks (2) of the airbag housing from the windows in the forward and rearward vertical walls of the airbag retainer (1) on the
underside of the top pad. To disengage the hooks, use hand pressure to push the adjacent edge of the airbag housing firmly and evenly downward
into the retainer receptacle, while at the same time pulling outward on the upper edge of the receptacle wall.
8. With all of the hooks disengaged, lift the housing, inflator, and cushion as a unit from the retainer receptacle on the underside of the instrument
panel top pad.
Passenger Airbag - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
WARNING: To avoid serious or fatal injury when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should
be worn. There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation to the skin and
eyes.