jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Windshield Washer Pump|Removal|Page 12336 > < Windshield Washer Pump|Description|Page 12333
Page 1
background image

Windshield Washer Pump: Service and Repair
Removal

Headlamp

HEADLAMP

NOTE: The headlamp washer pump/motor unit may be removed from the washer reservoir without removing the reservoir from the vehicle.

1. Disconnect and isolate the battery negative cable.
2. Siphon the washer fluid from the washer reservoir into a clean container for reuse.
3. Turn the steering wheel to move the front wheels to the full left position.
4. Raise and support the vehicle.
5. Remove the plastic push-in fasteners that secure the forward end of the left front wheelhouse splash shield to the inner fender panel and the front

fascia. See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Removal.

6. Pull the forward end of the left front wheelhouse splash shield away from the inner fender panel and front fascia far enough to access the headlamp

washer pump/motor unit (1) on the outboard side of the washer reservoir above and behind the reversible front and rear washer pump/motor unit
(3) for service.

7. Disconnect the headlamp and dash wire harness connector for the headlamp washer pump motor from the motor connector receptacle.
8. Disconnect the wire harness connector from the headlamp washer pump/motor unit (3).

9. Pull the molded plastic lock (2) away from the headlamp washer supply hose (1) quick connect fitting (4) far enough to disengage the hose from

the washer pump nipple (3).

10. Grasp the top of the washer pump/motor housing and pull it firmly outboard far enough to disengage the snap fit between the motor housing and

the molded motor receptacle in the reservoir.

11. Using hand pressure, firmly grasp and pull the washer pump upward far enough to disengage the pump inlet nipple from the rubber grommet

seal/filter screen in the reservoir. Care must be taken not to damage the reservoir.

12. Remove the rubber grommet seal/filter screen from the pump mounting hole in the washer reservoir and discard.

Reversible

REVERSIBLE

NOTE: The washer pump/motor unit may be removed from the washer reservoir without removing the reservoir from the vehicle.

Windshield Washer Pump|Removal|Page 12336 > < Windshield Washer Pump|Description|Page 12333