Grand Cherokee 2WD V8-4.7L Flex Fuel (2008)
Windshield Washer Pump: Service and Repair
Installation
Headlamp
HEADLAMP
1. Install a new rubber grommet seal/filter screen into the headlamp washer pump/motor unit mounting hole in the washer reservoir. Always use a
new rubber grommet seal on the reservoir.
2. Position the inlet nipple of the headlamp washer pump/motor unit (1) to the rubber grommet seal/filter screen in the reservoir.
3. Using hand pressure, press firmly and evenly downward on the washer pump/motor unit until the inlet nipple is fully seated in the rubber grommet
seal/filter screen in the pump mounting hole of the reservoir.
4. Using hand pressure, press the top of the washer pump/motor housing firmly inboard far enough to engage the snap fit between the motor housing
and the molded motor receptacle (4) in the reservoir.
5. Reconnect the vehicle wire harness connector to the connector receptacle on the top of the pump motor.
6. Seat the molded plastic lock (2) onto the washer supply hose (1) quick connect fitting (4).
7. Push the quick connect fitting onto the headlamp washer pump/motor unit outlet nipple (3) until it snaps into place with an audible click.
8. Reinstall the plastic push-in fasteners that secure the left front wheelhouse splash shield to the inner fender panel and the front fascia. See: Body
and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Installation.
9. Lower the vehicle.
10. Reconnect the battery negative cable.
11. Refill the washer reservoir with the washer fluid drained during removal.
12. Reconnect the battery negative cable.
Reversible
REVERSIBLE
