Grand Cherokee 2WD V8-4.7L VIN J (2004)
Fig. 12 Instrument Panel Antenna Cable Routing
9. Disengage the antenna cable retainer from the mounting hole in the top of the radio mount on the instrument panel structural duct.
10. Disengage the antenna cable from the locator tabs on the top of the instrument panel structural duct above the glove box opening.
11. Remove the antenna cable from the instrument panel.
INSTALLATION
1. Position the antenna cable onto the instrument panel.
2. Engage the antenna cable with the locator tabs on the top of the instrument panel structural duct above the glove box opening.
3. Engage the antenna cable retainer into the mounting hole in the top of the radio mount on the instrument panel structural duct.
4. Install the passenger side airbag module onto the instrument panel.
5. Install the radio receiver onto the instrument panel.
6. Engage the antenna cable retainer into the mounting hole in the wire harness mounting tab under the passenger side end of the instrument panel.
7. Reach under the passenger side of the instrument panel near the right cowl side inner panel to reconnect the antenna coaxial cable connector
halves.
8. Install the trim panel onto the right inner cowl side.
9. Install the scuff plate onto the right front door sill.
10. Reconnect the battery negative cable
