Grand Cherokee 2WD V8-4.7L VIN J (2004)
31.
Either enter the BCM part number (preferred and obtained earlier), or use the following criteria to select the flash from the drop down list:
a.
Select 2003 Model Year.
b.
Select WG Body Style.
c.
Select Engine.
NOTE:
The preferred method to select the correct software is by entering the current BCM part number into the ISIS Benchtop Programmer/DRBIII(R);
Winflash II application.
32.
Select the desired BCM Flash update, BCMWJGV047 - Version of 4.7 or later, from the table grid list on the computer.
33.
Click the Download button on the computer to send the file to the DRBIII(R).
34.
Connect the DRBIII(R) to the vehicle and select Vehicle Flash (Option 7) from the DRBIII(R) Main Menu.
35.
Carefully follow the instructions on the DRBIII(R) screen and complete the BCM reprogramming process. Power down the BCM by turning the
ignition switch to the OFF position.
36.
Cycle the ignition key at least twice, from OFF to RUN, to allow the ITM and BCM to learn.
37.
Perform the following BCM tasks:
a.
Reset country code setting in the BCM. Perform this operation even if the current country code is correct. This procedure will reset the
BCM. The country code setting is available in the DRBIII(R) Standalone Menu / Body Menu / Miscellaneous Menu.
b.
Cycle the ignition key at least twice, from OFF to RUN, to allow the BCM to learn.
c.
Verify that the EU DRL (European Day Time Running Lights) feature is disabled. If necessary, this feature can be disabled with the
DRBIII(R), and then verified by turning the headlamps and parking lamps to the OFF position and then turning the ignition key to the RUN
position. In this mode, the headlamps and/or parking lamps should not be illuminated if the EU DRL has been disabled.
NOTE:
The Vehicle Theft Security System (VTSS) / Vehicle Theft Alarm (VTA) and the ITM must be enabled once the ITM and the BCM have been
reprogrammed.
38.
From the DRBIII(R) Main Menu select DRBIII(R) Standalone (Option 1).
39.
From the Standalone Main Menu select 1998 - 2004 Diagnostics (Option 1).
40.
From the 1998 - 2004 Diagnostic Menu select ALL (Except Below) (Option 1).
41.
From the Select System Menu select Theft Alarm (Option 7).
42.
From the Anti-Theft Systems Menu select VTSS (VTA) (Option 1). Press ENTER to by-pass transient screen displays.
43.
From the Select Function Menu select Module Display (Option 3). Verify that the ITM S/W Version is 07.05 or later. Press the Page Back key to
exit the Module Display Menu.
44.
From the Select Function Menu select Miscellaneous (Option 9).
45.
From the Miscellaneous Function Menu select Configure ITM (Option 1). Follow the DRBIII(R) instructions for enabling the ITM.
46.
Cycle the ignition key at least twice, from OFF to RUN, to allow the ITM and BCM to learn.
47.
Check for faults in the BCM.
