Grand Cherokee 2WD V8-4.7L VIN J (2004)
Fig. 6
6. Remove plastic push pins attaching fascia to liftgate opening (Fig. 6).
7. Remove screws attaching fascia to liftgate opening.
8. Remove D pillar trim and scuff plate outboard screws.
9. Remove the rearward tie down screws and the aperture trim panel.
10. Carefully peel back the rubber body sealer patch to access the retainer clips.
11. Release the forward and rearward retainer clips on both sides of the fascia.
Fig. 7
12. Grasp forward edges of fascia and pull outward to disengage retainers attaching fascia to quarter panel (Fig. 7).
13. Separate fascia from vehicle.
INSTALLATION
Fig. 8
1. Position fascia on vehicle aligning retainers with slots in quarter panel (Fig. 8).
2. Press forward edges of fascia inward to engage retainers.
3. Install screws attaching fascia to liftgate opening.
4. Install plastic push pins attaching fascia to lift-gate opening.
5. Install nuts attaching upper edge of fascia to quarter panel and wheel liner.
6. Install plastic rivets attaching fascia to wheel liner.
7. Install support lower vehicle.
