Grand Cherokee 2WD V8-4.7L VIN J (2004)
Rear Door Panel: Service and Repair
Trim Panel
TRIM PANEL
REMOVAL
Fig. 10
1. Remove screws attaching trim panel to door (Fig. 10).
2. Using a trim stick C-4829 or equivalent, detach trim panel perimeter push-in fasteners from door inner panel.
3. Lift trim panel upward and separate from door.
4. Disconnect latch rods from inside handle actuator.
5. Disconnect harness connectors for power accessories.
6. Separate trim panel from vehicle.
INSTALLATION
1. Connect harness connectors to power accessories.
2. Connect latch rods to inside handle actuator.
3. Position trim panel on door inner panel.
4. Press trim panel push-in fasteners inward around perimeter of door.
5. Install screws attaching trim panel to door (Fig. 10).
