Grand Cherokee 2WD V8-4.7L VIN J (2004)
2. Grasp the edge of the trim and pull up gently to release the snap retainers.
INSTALLATION
1. Position the sill molding on the door sill.
2. Press the snap retainers into place.
Front Door Trim Panel
REMOVAL
1. Remove trim plug from mirror flag bezel.
Fig.14 Front Door Trim Panel
2. Remove three screws attaching trim panel to door.
3. Using trim remover (C-4829 or equivalent), detach trim panel perimeter push-in fasteners from door inner panel.
4. Lift trim panel upward and separate from door.
5. If equipped, disconnect harness connectors for power accessories.
6. Disconnect latch rods from inside handle actuator.
7. Separate trim panel from vehicle.
INSTALLATION
1. Connect latch rods to inside handle actuator.
2. If equipped, connect harness connectors to power accessories.
3. Position trim panel on door inner panel.
4. Press trim panel push-in fasteners inward around perimeter of door.
5. Install screws attaching trim panel to door.
6. Install trim plug in mirror flag bezel.
Liftgate Opening Upper Trim
LIFTGATE OPENING UPPER TRIM
REMOVAL
The upper liftgate opening trim is held on with spring clips.
