Grand Cherokee 2WD V8-4.7L VIN J (2004)
Fig. 1
3. Remove the seat belt turning loop from the height adjuster.
4. Remove the screw attaching lower b-pillar trim. (Fig. 1)
5. Pull lower b-pillar trim out far enough to remove upper trim panel.
6. Grasp upper b-pillar trim at lower edge and pull outward then down to detach from b-pillar.
INSTALLATION
1. Position b-pillar trim panel on b-pillar. (Fig. 1)
2. Install screw attaching lower b-pillar trim panel.
3. Position the seat belt turning loop onto the height adjuster on the upper B-pillar.
4. Install screw that secures the seat belt turning loop to the height adjuster and tighten to 37 N.m (27 ft. lbs.).
5. Using hand pressure, press the top of the turning loop trim cover to snap it onto the height adjuster and cover the screw that secures the front seat
belt turning loop to the adjuster on the upper B-pillar. (Fig. 3)
C-Pillar Trim
C-PILLAR TRIM
REMOVAL
1. Fold the rear seat cushion forward against the back of the front bucket seat.