Grand Cherokee 2WD V8-4.7L VIN J (2004)
21.
Peel off the paper on the adhesive backed heating element and attach the new center cushion heating element as shown in Figure 4. This is the
element in the kit that has four electrical connectors.
NOTE:
Each heating element in the kit has a label attached that indicates its intended location.
22.
Peel off the paper from each of the adhesive backed side bolster heating elements and attach each heating element to the seat cushion foam as
shown in Figure 4.
23.
Connect the bolster wiring connectors to the center heating element wiring harness.
24.
Route the wiring harness between the rear seat bar and the seat cushion foam.
25.
Place the seat cushion cover into position over the seat cushion foam.
