Grand Cherokee 2WD V8-4.7L VIN J (2004)
17. Unlatch the front " J" strap.
18. Turn the seat over and carefully lift the seat cover to expose the upholstery rings. Carefully cut off all of the upholstery rings.
19. Carefully remove the seat cover from the foam seat cushion.
20. Carefully remove and discard all of the old seat heater element from the seat foam.
CAUTION:
Never apply the new heating element over the old element. The old heating element must be removed and discarded.
21. Peel off the paper on the adhesive backed heating element and attach the new center cushion heating element as shown in Figure 3. This is the
element in the kit that has four electrical connectors.
CAUTION:
Ensure that all areas of each element are flat and fully attached to the seat foam. When properly installed, there should be no buckled or folded areas
in the heating element. It is also important to maintain the gaps (slits) in the heating elements and ensure that the edges of the elements (along the
slits) do not contact one another. The seat back and cushion elements are not interchangeable. Each element is labeled for its intended location (back
or cushion). Failure to install the heating elements as described and shown in this procedure may cause damage to the seat cover(s).
22. Route the wiring harness between the rear seat bar and the seat cushion foam.
23. Turn the seat cover inside out.
24. Place the seat cushion cover into position over the seat cushion foam.
