Grand Cherokee 2WD V8-4.7L VIN J (2004)
Power Seat Switch: Service and Repair
Driver Seat Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.4 Removing Switch Control Knobs
2. On models with the ten-way power seat system only using a push pin remover or another suitable wide flat-bladed tool, gently pry the power seat
and power recliner switch knobs off of the switch stems.
3. Remove the three screws that secure the outboard seat cushion side shield to the seat cushion frame.
4. Pull the outboard seat cushion side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
5. Disconnect the power seat wire harness connector from the power seat switch connector receptacle.
Power Seat Switch Remove/Install - Typical
