Grand Cherokee 2WD V8-4.7L VIN J (2004)
Caliper Installed
2. Install the caliper on the adapter.
3. Install the caliper slide pin bolts and tighten to 72 Nm (53 ft. lbs.).
4. Gently lift one end of the slide pin boot to equalize air pressure, then release the boot and verify that the boot is fully covering the slide pin.
5. Install brake hose to caliper with new gasket washers and tighten banjo bolt to 31 Nm (23 ft. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening banjo bolt.
6. Fill and bleed brake system.
7. Install wheel and tire assemblies.
8. Remove supports and lower vehicle.
9. Verify brake fluid level.
Disassembly
DISASSEMBLY- FRONT DISC BRAKE CALIPER
1. Drain the brake fluid from caliper.
Clamp One Piston
2. C-clamp a block of wood over one piston.