Grand Cherokee 2WD V8-4.7L VIN J (2004)
Caliper Anchor Bolts
3. Remove the caliper anchor bolts.
4. Remove caliper and anchor as an assembly.
5. Secure caliper anchor assembly to nearby suspension part with wire. Do not allow brake hose to support caliper weight.
6. Remove retainers securing rotor to axle studs.
7. Remove rotor off axle studs.
INSTALLATION - REAR DISC BRAKE ROTOR
1. Install rotor on axle studs.
2. Install the caliper anchor assembly.
3. Install anchor bolts and tighten to 90 - 115 Nm (66 - 85 ft. lbs.).
4. Install wheel and tire assembly.
5. Remove support and lower the vehicle.
6. Pump brake pedal until caliper pistons and brake shoes are seated.
