Grand Cherokee 2WD V8-4.7L VIN J (2004)
Coolant Line/Hose: Service and Repair
WATER PUMP INLET TUBE
REMOVAL
WARNING: CONSTANT TENSION HOSE CLAMPS ARE USED ON MOST COOLING SYSTEM HOSES. WHEN REMOVING OR
INSTALLING, USE ONLY TOOLS DESIGNED FOR SERVICING THIS TYPE OF CLAMP, SUCH AS SPECIAL CLAMP TOOL
(NUMBER 6094). SNAP-ON CLAMP TOOL (NUMBER HPC-20) MAY BE USED FOR LARGER CLAMPS. ALWAYS WEAR SAFETY
GLASSES WHEN SERVICING CONSTANT TENSION CLAMPS.
CAUTION: A number or letter is stamped into the tongue of constant tension clamps. If replacement is necessary, use only an original equipment
clamp with matching number or letter.
1. Partially drain cooling system.
2. Do not waste reusable coolant. If solution is clean, drain coolant into a clean container for reuse.
3. Loosen both bypass hose clamps and position to center of hose. Remove hose from vehicle.
INSTALLATION
1. Position bypass hose clamps to center of hose.
2. Install bypass hose to engine.
