Grand Cherokee 2WD V8-4.7L VIN J (2004)
INSTALLATION
1. Install exhaust manifold and gasket from below engine compartment.
2. Install lower exhaust manifold fasteners . DO NOT tighten until all fasteners are in place.
3. Lower vehicle and install upper exhaust manifold fasteners . Tighten all manifold bolts starting at center and working outward to 25 Nm (18 ft.
lbs.).
CAUTION: Over tightening heat shield fasteners, may cause shield to distort and/or crack.
4. Install exhaust manifold heat shield. Tighten fasteners to 8 Nm (72 in. lbs.), then loosen 45 degrees.
5. Install air cleaner housing and tube.
6. Connect exhaust pipe to manifold.
7. Connect negative cable to battery.
