Grand Cherokee 2WD V8-4.7L VIN J (2004)
Glove Box Lamp Switch: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO ELECTRICAL, RESTRAINTS BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Roll down the glove box from the instrument panel.for the procedures.
3. Remove the lower right center bezel from the instrument panel.for the procedures.
4. Reach through the glove box opening and depress the retaining latches on the top and bottom of the glove box lamp and switch housing.
5. While holding the retaining latches depressed, push the glove box lamp and switch out through the mounting hole.
6. Disconnect the instrument panel wire harness connector from the glove box lamp and switch connector.
7. Remove the glove box lamp and switch.
INSTALLATION
1. Position the glove box lamp and switch to the instrument panel.
2. Reconnect the instrument panel wire harness connector to the glove box lamp and switch connector.
3. Align the glove box lamp and switch housing with the mounting hole in the instrument panel glove box opening upper reinforcement.
4. Push the glove box lamp and switch into the mounting hole until the retaining latches are fully engaged.
5. Install the lower right center bezel onto the instrument panel. for the procedures.
6. Roll the glove box back up into the instrument panel.for the procedures.
7. Reconnect the battery negative cable.
