Grand Cherokee 2WD V8-4.7L VIN J (2004)
Horn Switch: Description and Operation
A center-blow, normally open, resistive membrane-type horn switch is secured in a plastic tray that is inserted in a pocket sewn on the front of the driver
side airbag retainer strap. The horn switch is concealed behind the driver side airbag module trim cover in the center of the steering wheel. The switch
consists of two plastic membranes, one that is flat and one that is slightly convex. These two membranes are secured to each other around the perimeter.
Inside the switch, the centers of the facing surfaces of these membranes each has a grid made with an electrically conductive material applied to it. One
of the grids is connected to a circuit that provides it with continuity to ground at all times. The grid of the other membrane is connected to the horn relay
control circuit.
The steering wheel and steering column must be properly grounded in order for the horn switch to function properly. The horn switch and plastic tray are
serviced as a unit. If the horn switch is damaged or faulty, or if the driver side airbag is deployed, the horn switch and tray must be replaced as a unit.
When the center area of the driver side airbag trim cover is depressed, the electrically conductive grids on the facing surfaces of the horn switch
membranes contact each other, closing the switch circuit. The completed horn switch circuit provides a ground for the control coil side of the horn relay,
which activates the relay. When the horn switch is released, the resistive tension of the convex membrane separates the two electrically conductive grids
and opens the switch circuit.
