Grand Cherokee 2WD V8-4.7L VIN J (2004)
upper glove box opening reinforcement.
6. Remove the passenger airbag from the instrument panel structural duct as a unit.
7. If the passenger airbag has been deployed, carefully inspect the airbag mounting points on the instrument panel structural duct. If the airbag
mounting points have been damaged or deformed, the instrument panel structural duct must be replaced.
INSTALLATION
1. Carefully position the passenger airbag unit onto the instrument panel structural duct.
2. Install and tighten the four screws that secure the passenger airbag to the instrument panel structural duct. Tighten the screws to 12 Nm (105 in.
lbs.).
3. Reconnect the passenger airbag pigtail wire connector to the instrument panel wire harness connector for the airbag. This connector is secured to
the outside of the outboard airbag unit end bracket. Be certain that the latch on the connector and the red Connector Position Assurance (CPA)
lock are each fully engaged.
4. Reinstall the top pad onto the instrument panel.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
