Grand Cherokee 2WD V8-4.7L VIN J (2004)
Seat Belt: Service and Repair
Seat Belt and Retractor - Rear Center
REMOVAL
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS
A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED
REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.
1. Unlatch and fold the right rear seat cushion forward.
Fig.33 Rear Center Seat Belt Lower Anchor Remove/Install
2. Remove the screw that secures the rear center seat belt lower anchor to the right rear seat belt buckle unit bracket on the rear floor panel.
3. Unlatch and fold the right rear seat back forward and separate the cargo area carpet from the base of the seat back panel.
4. Remove the right rear seat back panel from the vehicle.
5. Remove the two screws that secure the belt web guide to the top of the right rear seat back panel.
6. Remove the trim from the right rear seat back.
7. Route the rear seat belt lower anchor and belt web guide through the top of the seat back panel.
