Grand Cherokee 2WD V8-4.7L VIN J (2004)
3. Install and tighten the screw that secures the retractor bracket to the mounting tab on the inner and outer rear wheelhouse flange. Tighten the screw
to 43 Nm (32 ft. lbs.).
4. Reinstall the trim onto the quarter inner panel.
5. Position the seat belt turning loop to the height adjuster on the upper C-pillar.
6. Install and tighten the screw that secures the seat belt turning loop to the height adjuster. Tighten the screw to 37 Nm (27 ft. lbs.).
7. Using hand pressure, press the top of the turning loop trim cover to snap it onto the height adjuster and cover the screw that secures the rear
outboard seat belt turning loop to the adjuster on the upper C-pillar.
8. Position the rear outboard seat belt lower anchor to the rear floor panel.
9. Install and tighten the screw that secures the seat belt lower anchor to the rear floor panel. Tighten the screw to 43 Nm (32 ft lbs).
10. Fold the rear seat cushion back into the seating position.
