Grand Cherokee 2WD V8-4.7L VIN J (2004)
Fig. 30 Turning Loop Cover Remove/Install
5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the top of the turning loop trim cover to unsnap it from the height adjuster
and access the screw that secures the front seat belt turning loop to the adjuster on the upper B-pillar.
6. Remove the screw that secures the seat belt turning loop to the height adjuster on the upper B-pillar.
7. Remove the seat belt turning loop from the height adjuster.
8. Remove the trim from the lower B-pillar.
9. Pull the front seat belt turning loop and lower anchor through the access hole in the lower B-pillar trim.
Fig. 31 Front Retractor
10. Remove the plastic push-in fastener that secures the retractor to the lower B-pillar.
11. Disengage the retractor locator tab from the slot in the B-pillar.
12. Remove the front seat belt and retractor from the B-pillar as a unit.
INSTALLATION
1. Position the front seat belt and retractor to the B-pillar as a unit. Be certain to engage the retractor locator tab in the slot in the lower B-pillar.
2. Using hand pressure, install the plastic push-in fastener that secures the retractor to the lower B-pillar.
3. Push the seat belt lower anchor and turning loop through the access hole in the lower B-pillar trim.
4. Reinstall the trim onto the lower B-pillar.
5. Position the seat belt turning loop onto the height adjuster on the upper B-pillar.
6. Install and tighten the screw that secures the seat belt turning loop to the height adjuster. Tighten the screw to 37 Nm (27 ft. lbs.).
7. Using hand pressure, press the top of the turning loop trim cover to snap it onto the height adjuster and cover the screw that secures the front seat
belt turning loop to the adjuster on the upper B-pillar.
