Grand Cherokee 2WD V8-4.7L VIN J (2004)
Power Seat Switch: Service and Repair
Memory Set Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the driver side front door. Refer to Front Door Trim Panel in Body for the procedure.
3. Disconnect the memory switch wire harness connector from the driver door module connector receptacle.
4. Remove the two screws that secure the memory switch to the back of the driver side front door trim panel.
5. Remove the memory switch from the back of the driver side front door trim panel.
INSTALLATION
1. Position the memory switch onto the back of the driver side front door trim panel.
2. Install and tighten the two screws that secure the memory switch to the back of the driver side front door trim panel. Tighten the screws to 2.2 Nm
(20 in. lbs.).
3. Reconnect the memory switch wire harness connector to the driver door module connector receptacle.
4. Install the trim panel onto the driver side front door. Refer to Front Door Trim Panel in Body for the procedure.
5. Reconnect the battery negative cable.
