Grand Cherokee 2WD V8-4.7L VIN J (2004)
6. Remove nut mounting valve stem of pressure sensor/transmitter to the wheel. Drop sensor/transmitter into tire.
CAUTION: When breaking the top and bottom bead of the tire off the wheel, care must be used so the bead breaking mechanism on the tire changer
does not damage the wheel. This includes the surface of the wheel flange on the inside of the wheel.
7. Using the tire changer manufacturers procedure, first break down the upper bead of the tire. Then break down the bottom bead of the tire.
CAUTION: When dismounting the upper tire bead from the wheel, the proper procedure must be used. Not using the proper procedure will result in
damage to the wheel and tire.
8. Dismount the upper bead of the tire from the wheel. The upper bead must be fully dismounted from the wheel to remove the tire pressure
transmitter from the inside of the tire. The bottom bead of the tire does not need to be removed from the wheel.
9. Pull upward on the tire. Reach into the tire and remove the pressure sensor/transmitter from inside the tire.
INSTALLATION - TIRE PRESSURE SENSOR/TRANSMITTER
NOTE: When installing the tire pressure sensor/transmitter, inspect the sealing O-ring at the bottom of the valve stem for any sign of damage or
deterioration. Replace O-ring if necessary, before installing the pressure transmitter on the wheel. Also, be sure the surface of the wheel that the O-ring
seals against is clean and not damaged.
