Grand Cherokee 2WD V8-4.7L VIN J (2004)
Center Link: Service and Repair
REMOVAL
1. Raise and support the vehicle.
2. Remove right wheel and tire assembly.
3. Remove the cotter pins and nuts at the right steering knuckle and pitman arm.
4. Remove the drag link from the steering knuckle and pitman arm Puller C-3894-A.
5. Loosen adjustment sleeve clamp bolts and unscrew the tie rod ends from the adjustment sleeve.
INSTALLATION
1. Screw the tie rod ends into the adjustment sleeve.
2. Install the drag link onto the right steering knuckle and pitman arm.
3. Tighten the nut at the steering knuckle to 47 Nm (35 ft. lbs.). Tighten the pitman nut to 88 Nm (65 ft. lbs.). Install new cotter pins.
4. Position clamp bolts to their original position and tighten to 41 Nm (30 ft. lbs.).
5. Install right wheel and tire assembly.
6. Remove support and lower the vehicle.
7. Center the steering wheel.
