Grand Cherokee 2WD V8-4.7L VIN J (2004)
7. Remove the pitman shaft oil seal retaining ring with snap ring pliers.
8. Remove oil seal metal backup washer then plastic backup washer from the housing.
9. Remove pitman shaft oil seal from the housing with a Puller 7794-A and Slide Hammer C-637.
10. Drop Driver 8277 through the top bearing and align the driver up with the lower bearing.. Install Handle C-4171 into the driver and remove the
lower bearing.
11. Turn the gear over and remover the upper bearing with Driver 8277 and Handle C-4171.
