jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Suspension - Front Suspension Squeak/Squawk Noises|Page 6083 > < Suspension - Front Suspension Squeak/Squawk Noises|Page 6077
Page 1
background image

Stabilizer Bushing: All Technical Service Bulletins
Suspension - Front Suspension Squeak/Squawk Noises

NUMBER: 02-002-04 REV. A

GROUP: Suspension

DATE: May 25, 2004
 
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 02-002-04, DATED MARCH 16, 2004, WHICH SHOULD BE REMOVED
FROM YOUR FILES. THIS IS A COMPLETE REVISION AND NO ASTERISKS HAVE BEEN USED TO HIGHLIGHT REVISIONS. A
SUFFICIENT QUANTITY OF THE REQUIRED MOPAR LUBRICANT WILL NOT BE AVAILABLE UNTIL JULY 01, 2004.

SUBJECT:
Suspension Squeak/Squawk - Front Stabilizer Bar Bushings

OVERVIEW:
This bulletin involves the lubrication of the front stabilizer bar and bushings.

MODELS:

1999-2004

(WJ/WG)

Grand Cherokee

SYMPTOM/CONDITION:

A squeak or squawk-like sound may be present in the front or rear suspension. Closer investigation may reveal that the sound is coming from one or
more of the vehicle front stabilizer bar bushings. The sound may occur most often when the ambient temperature is around 0° C (32°F).

DIAGNOSIS:

If the customer experiences the above condition perform the Repair Procedure.

PARTS REQUIRED:

REPAIR PROCEDURE:

1.

Raise and support the vehicle.

2.

Remove the bolts that attach the front stabilizer bar retainers to the frame rails.

3.

Remove the stabilizer bar bushings.

4.

On 2004 model year vehicles discard the old bushings and replace with new bushings, p/n 52088284AE. New bushings will require lubrication.
Replacement bushings are not required for 1999 - 2003 model year vehicles.

5.

Thoroughly clean the surface of the stabilizer bar in the areas where the bushings contact the bar. Make sure that there is no foreign material or
build up of rubber on the stabilizer bar.

6.

Apply a liberal coating of Mopar Lubricant, p/n 05019061AA, to the surfaces of the stabilizer bar where each bushing is positioned when
assembled to the vehicle.

7.

Thoroughly lubricate the entire inside surface of each bushing.

8.

Install each bushing to the front stabilizer bar. Install the bushing retainers and attaching bolts. Tighten the attaching bolts to 92 Nm (68 ft. lbs.).

9.

Lower vehicle.

Suspension - Front Suspension Squeak/Squawk Noises|Page 6083 > < Suspension - Front Suspension Squeak/Squawk Noises|Page 6077