Grand Cherokee 2WD V8-4.7L VIN J (2004)
2. Tighten the tire pressure sensor/transmitter mounting nut to a torque of 7 Nm (64 inch lbs.). When tightening the sensor/transmitter nut, hold the
transmitter so it does not rotate. If the sensor/transmitter rotates so the top edge is not level with the wheel, damage to the transmitter will occur
when mounting the tire. If the top edge of the transmitter is not level with the wheel, it can be rotated into position by lightly tapping it with your
hand.
CAUTION: When mounting the upper bead of the extended mobility tire, the proper procedure must be used. Not using the proper procedure will result
in damage to the wheel and tire.
3. Mount the upper bead of the tire on the wheel.
4. Install the original or an OEM replacement valve stem cap on the valve stem.
5. Using a soap solution, check that no air leak is present where the valve stem mounts to the wheel.
6. Balance the tire/wheel assembly using the correct procedure for using wheel flange mount and stick-on wheel weights. For balancing information
and wheel weight positioning.
7. Install the tire/wheel on the vehicle.
8. Program the identification code for the new tire pressure sensor/transmitter into the TPM module.
9. Verify that the TPM module has been programmed with the identification code from the new tire pressure sensor/transmitter. If the identification
code and tire pressure thresholds from the new tire pressure transmitter are present in the receivers memory the new tire pressure transmitter has
been correctly programmed to the receiver.
