Grand Cherokee 2WD V8-4.7L VIN J (2004)
8. Remove the nuts holding the shift cable seal plate to the floor pan (Fig. 105).
9. Pull cable through floor panel opening.
10. Remove shift cable from vehicle.
INSTALLATION
1. Route cable through hole in floor pan.
2. Install seal plate to studs in floor pan.
3. Install nuts to hold seal plate to floor pan. Tighten nuts to 7 Nm (65 in. lbs.).
4. Install the shift cable to the shifter assembly bracket. Push cable into the bracket until secure.
5. Place the floor shifter lever in PARK position.
6. Loosen the adjustment screw on the shift cable.
7. Snap the shift cable onto the shift lever pin.
8. Raise the vehicle.
9. Install the shift cable to the shift cable support bracket.
10. Shift the transmission into PARK. PARK is the rearmost detent position on the transmission manual shift lever.
11. Snap the shift cable onto the transmission manual shift lever.
12. Lower vehicle.
13. Verify that the shift lever is in the PARK position.
14. Tighten the adjustment screw to 7 Nm (65 in. lbs.).
15. Verify correct shifter operation.
16. Install any console parts removed for access to shift lever assembly and shift cable.
