Grand Cherokee 2WD V8-4.7L VIN J (2004)
4. Install yoke with Screw 8112, Cup 8109 and Spanner Wrench 6958 (Fig. 39).
5. Install yoke washer and new nut on the pinion gear. Tighten the nut to 271 Nm (200 ft. lbs.).
CAUTION: Never loosen pinion gear nut to decrease pinion rotating torque and never exceed specified preload torque. If preload torque or
rotating torque is exceeded a new collapsible spacer must be installed.
NOTE: New collapsible spacers require high initial torque to start the collapsing of the spacer. This may reach 678 Nm (500 ft. lbs.).
